SERVICES AVAILABLE:
1) Moisture Testing your concrete floor slab in accordance with ASTM F2170
standards. This is an often overlooked, but very important
preliminary step and service we offer. We recommend every client
have moisture testing done before moving forward with a coating
installation. For starters, the test allows us to determine if
your floor is suitable for a floor coating system. It will also
give us the data necessary to choose the appropriate coating system
that will be most suitable for your floor. Not all contractors
place high importance on this crucial step, but it is an important
preventive measure that can help reduce risk of a future flooring
failure (delamination of coatings from floor due to excessive moisture vapor transmission in a floor).
2) Cleaning/Degreasing/Power-Scrubbing & Extracting
to remove potential contaminants. This is usually
a necessary step in the preparation process for garages, shops,
manufacturing, or other facilities that
have used oils, greases, silicone products, and/or other
maintenance fluids on the floor
area to be coated. Though a floor may look generally clean, these
contaminants can be embedded into the surface pores of the concrete
floor. Such contaminants can cause epoxy, urethane, and other
coatings to separate while being applied, and leave your finished floor
looking less than desirable.
Degreasing
prior to mechanically profiling the concrete, ensures a more thorough
removal of any existing contaminants that may be in the floor surface.
3) Edge-Grinding with diamond grinders to obtain appropriate surface profile for superior coating adhesion.
4) Shot blasting of concrete floors to clean & obtain appropriate surface profile for superior coating adhesion.
5) Crack-Repairs & Patching prior to coating system installation, to provide the best finished look possible.
6) Installation of coating system on properly prepared floor surface.